Re: [Libguestfs] [p2v PATCH 14/15] create_conversion_dialog(): add button to refresh disks & removables
On Mon, Sep 19, 2022 at 03:35:10PM +0200, Laszlo Ersek wrote:
+At the bottom of the dialog, the C<Refresh disks> button
instructs
+virt-p2v to re-enumerate the fixed hard disks and the removable media
+drives. (Note that the button will also reset the currently active
+selections in both of those panels.) This button is useful in
+combination with the C<XTerm> button on the L</SSH CONFIGURATION
+DIALOG>: in the XTerm window, you can expose further block devices to
+the kernel (such as LUNs from iSCSI targets), and the C<Refresh disks>
+button allows virt-p2v to learn about all the block devices again.
+
│
Network interfaces │
│
^
Here (and earlier) in the same file ...
@@ -239,10 +248,10 @@ the interface to be identified by the
operator.
When you are ready to begin the conversion, press the
C<Start conversion> button:
- │
- [ Back ] [ Start conversion ] │
- │
- ─ ─ ───────────────────────────────────────┘
+ │
+ [ Back ] [ Refresh disks ] [ Start conversion ] │
+ │
+ ─ ─ ──────────────────────────────────────────────────────────┘
... I think you need to move the │ (vertical line) in the earlier
sections over to the right to line up.
Rich.
--
Richard Jones, Virtualization Group, Red Hat http://people.redhat.com/~rjones
Read my programming and virtualization blog: http://rwmj.wordpress.com
virt-builder quickly builds VMs from scratch
http://libguestfs.org/virt-builder.1.html